1.5V LED FLasher Using 3 Transistors | Schematic Diagrams


Schematic Diagrams

Useful schematic and wiring diagrams. ✔ ✔ Enjoy electronic circuits, let your idea comes to hardware

1.5V LED FLasher Using 3 Transistors

]]>

To make LED works, you need a voltage source that is higher than the LED’s forward bias voltage, and it’s higher that 1.5V (around 2V for red LEDs). Fortunately, now you can make a LED flasher circuit that needs only 1.5V or a single cell battery to work. Here is the schematic diagram of the circuit:

low voltage led flasher transistor circuit schematic diagram

The core of this LED flasher scircuit is a capacitor charge pump, to make a higher voltage.  You can see the final transistor driver is connected to a 330 ohm resistor. When this transistor is switched off, the 220uF capacitor is charged to 1.5V via two 330 ohm resistor. After the capacitor is full of charges, then when the transistor is switched on, the voltage acrros the LED is the supply voltage plus the capacitor voltage, or about 3V, and now the current will flow from the supply through the LED, capacitor, and transistor.

Most Wanted Diagrams:

]]>

Comments are currently closed.

Sponsored Link

    ]]>

Categories

Schematic Search

BatteryBlower motorBuickCadillacChevroletCigar LighterCircuit DiagramDodgeelectrical circuitElectrical SchematicElectrical SystemFordFuel PumpFuel Pump Relayfusefuse blockfuse boxFuse Holderfuse layoutfuse mapfuse panelGMCHeadlampHeaterHondaHornHorn RelayIgnition coilIgnition switchInstrument ClusterInstrument panelOldsmobilePontiacPower WindowRadioRelayschematic diagramStarter RelayStop LampStudebakerTurn SignalWiperWiring Diagrawiring diagramWiring Harnes

Schematic Diagrams

Powered by WordPress. Designed by SuperSidor. Schematic Diagram

Recent Posts