0 to 40V Lab Power Supply – Schematic Diagrams

0 to 40V Lab Power Supply Schematic Diagrams      Comments Off on 0 to 40V Lab Power Supply

A very lab adjustable
power supply that can provide an output voltage between 0 and 60 volts
can be designed using this circuit diagram . This lab power supply can
be designed with LM723 chip or for higher output voltages, with L146
.Output current is also adjustable, but once established, is always
effective. Table 1 shows the values to be modified to have three
different versions of the maximum output voltage (30, 40 and 60 V).

Electrical diagram below shows the alternative 40 V / 0.8 using L146
chip because it can stabilize higher output voltage, much better than
the LM723. Normally, 2 V is the minimum voltage stabilized that even an
integrated circuit can provide. Resistive network R3, R4 and R5, R6
“kill” this restriction so that output can be set to 0 V with
potentiometer P2.

Depending on the output requirements, will be decided on the type
and the semiconductor capacitors to be used. Output current must be
limited so as to keep power dissipation of 40 W. T3 under maximum output
current for 40 V version is 0.8 A. It can connect two parallel 2N3055
transistors (with emitter resistors) to double the current output, but
in this case requires a 2 A transformer

    , , ,

Post navigation

Recent Posts