Wire Tracer (Transmitter)

Schematic Diagrams      Comments Off on Wire Tracer (Transmitter)

The circuit depicted
here forms one half of a device that will prove extremely handy when
tracing the path of electrical wiring in a building or to locate a break
in a wire. The system is based on similar equipment that is used by
technicians in telephone exchanges. The operation is straightforward.
You require a generator that delivers an easily recognizable signal
which, using a short antenna, is inductively coupled to a simple, but
high gain, receiver. To create a useful transmitter it would suffice to
build a simple generator based on a 555. But as the adjacent diagram
shows, a 556 was selected instead. The second timer (IC1a) is used to
modulate the tone produced by IC1b.

Circuit

Circuit diagram

The output frequency alternates between about 2100 Hz and 2200 Hz.
This is a very distinctive test signal that is easily distinguished from
any other signals that may be present. Resistor R6 is connected to a
piece of wire, about ten centimeters long, that functions as the
antenna. The ground connection (junction C2-C3) is connected to ground.
When the antenna is connected directly to a cable, it is possible to
determine at the other end of the cable, with the aid of the receiver,
which conductor is which (don’t do this with live conductors!). The
schematic for the matching receiver may be found elsewhere in this
website.