Starting Up Your TMCM-110 into Stepper Motor Motion Systems

Schematic Diagrams      Comments Off on Starting Up Your TMCM-110 into Stepper Motor Motion Systems
[Stepper Motor] Starting Up Your TMCM-110 into Stepper Motor Motion Systems: how-to-start-your-tmcm-110-into-stepper-motor-motion-systems.jpg

how to start your TMCM-110 into Stepper Motor Motion SystemsThis schematic figure show you about how to start your TMCM-110 into Stepper Motor Motion Systems. The TMCM-110  stepper
motor equipped with a 4 pin, a 5 pin and an 8 pin JST PHR-connector
with about 20 cm cables for each pin. No need to connect extra motor if
you have PANdrive TMCM-110 is mounted to a motor.

In order to install TMCM-110 device, you will need your stepper motor controller
and driver module, connect it with 12V to 30V of power supply,
interface suitable to the device version such RS232, RS485, CAN or IIC
with cables and converter supplied, TMCL IDE program and Personal
Computer.

Has to be noted that never connect or disconnect motors while powered, bundling IO wires with motor power wires may lead to noise pickup from the motor, and never exceed the maximum power supply of 30V. You will be taken to sections about Starting Up Your TMCM-110 into Stepper Motor Motion Systems in step by step,
setting the TMCL IDE, Manual Programming Commands to set motion and
control parameters, the TMCM-110 Communication and Motor
Troubleshooting.

See complete article about Starting Up Your TMCM-110 into Stepper Motor Motion Systems in pdf filetype here in the datasheet application here (source: trinamic.com)