555 Timer Circuit With Variable On/Off Times

Schematic Diagrams      Comments Off on 555 Timer Circuit With Variable On/Off Times

This circuit enables the
on/off times of a 555 timer to be independently varied over a wide
range. This is not possible with a conventional 555 circuit with the RC
network being charged from the positive supply rail and discharged via
pin 7. Instead, the capacitor at pins 2 & 6 of IC1 is charged and
discharged from the output at pin 3. Furthermore, the charging and
discharging circuits are different, being isolated by diodes D1 &
D2.

Circuit diagram:

555 Timer Circuit With Variable On/Off Times

555 Timer Circuit Diagram With Variable On/Off Times

Therefore the capacitor at pins 2 & 6 is charged via diode D2
and trimpot VR2 and discharged via D1 and trimpot VR1. With this
arrangement you can have very long on times combined with very short off
times and vice versa, or you can adjust the duty cycle to exactly 50%
and so on. This circuit also employs a second 555 timer (IC2) as an
inverter so that complementary pulses are available, if required. If
not, delete IC2.
Author: A. Davies – Copyright: Silicon Chip Electronics